access-point

Linux 5GHz access point REGULATORY DOMAIN problem (debian+ hostpad + dnsmasq)

Linux 5GHz access point REGULATORY DOMAIN problem (debian+ hostpad + dnsmasq) I am getting problems setting a 5GHz access point with a lattepanda 3d. I run the following setup: Debian Hostapd Dnsmasq iw (for set/get reg dom) In the end I am able to successfully test a 2,4 GHz AP setup. No way to get …

Total answers: 1

Wireless AP, I cannot ping host nor client

Wireless AP, I cannot ping host nor client I’m setting up a wireless ap without internet connection. A client can connect to the hostapd server and obtain an ip address thanks to dnsmasq. The problem is that the client cannot ping the server and the server cannot ping the client. My server is a raspberry …

Total answers: 1

Why can't hostapd service start AP configured in the 5 GHz band using Intel AX200 based adapter?

Why can't hostapd service start AP configured in the 5 GHz band using Intel AX200 based adapter? I am trying to set up an AP using the following configuration: Wi-Fi adapter: TP-Link AX3000 (Intel AX200 based) Operating system: Ubuntu Server 20.10 (groovy) Kernel version: 5.8.0-44-generic Firmware: iwlwifi-cc-a0-55.ucode AP service: hostapd v2.9 (tried the custom-build from …

Total answers: 2

wpa_supplicant doesn't auto-change AP

wpa_supplicant doesn't auto-change AP (I was trying and trying for hours to find a workaround, which proved much harder than initially expected.) The problem itself is easy to understand, though. I recently installed a GUI-less Debian derivative on one of my machines and configured /etc/wpa_supplicant/wpa_supplicant.conf to access one of my access points and that worked …

Total answers: 1

Single wifi card, Connect to multiple access points simultaneously

Single wifi card, Connect to multiple access points simultaneously As we know, We can create virtual wireless interface using iw dev (1). Also, We can change it’s MAC address using ifconfig <ifname> hw ether <Address>. Then We can Set two different access points (SSIDs) to each of these inetrfaces using Network Manager. For example: (Real) …

Total answers: 2

Create wireless access point and share internet connection with nmcli

Create wireless access point and share internet connection with nmcli How can I create a Wi-Fi hotspot with the command line tool nmcli and share/bridge the ethernet internet connection with the wireless access point? Furthermore, how can I start this automatically at boot? Is this possible with nmcli? Asked By: BuZZ-dEE || Source I created …

Total answers: 6

Internet connection lost after installing dnsmasq

Internet connection lost after installing dnsmasq I’m currently trying to set up an access point on my raspberry pi, but as soon as I install ‘dnsmasq’, the internet connection is lost (‘unknown host’ when trying to ping any server). What causes this and how do I connect it to the internet again? P.S.: i can …

Total answers: 2